Inside the new MacBook Air's screen

Almost immediately after Apple launched the new MacBook Air, TechRestore began offering a matte finish screen replacement for its glossy screen. I asked CEO Shannon Jean a few questions about getting inside the new MBA:

p.p1 {margin: 0.0px 0.0px 0.0px 0.0px; font: 13.0px Verdana} p.p2 {margin: 0.0px 0.0px 0.0px 0.0px; font: 13.0px Verdana; min-height: 16.0px}

Q. Who’s panel are you using? Is it the same OEM that Apple uses?

A. Same exact specs – there’s only one panel like this being made right now.

Q. Is it any easier to get inside MBA now that there’s less electronics in the display? (i.e. no microphone?)

A. It’s much more difficult. The screen is paper thin and it’s not inside a housing like the traditional screens. It’s in layers, it’s insane. Perhaps you can do a post on this service, then I can send you images of the screen to do an additional post. I don’t think there’s ever been a screen like this used in a laptop. It’s very similar to a Sony PSP screen, where the LCD panel and backlight are separate pieces.

Q. Anything else on the new screen?

A. Like I mentioned, this is an ultra-thin screen that is not encased in a typical screen housing. Looks like Apple saved weight and space by keeping the parts separate. Very cool, except getting the screen out of the unit is a challenge with the Iron Man adhesives that Apple uses. Plus the fact that replacing the screen will require a dust free environment, since you are essentially peeling back the screen like an onion and there are all kinds of ways to cause damage. If you scratch the backlight layer, it will show through the LCD, if you get dirt/dust in between the LCD and reflective layers, it will show up, just to name a few.

Q. Have you taken your MBA apart yet?

A. Photos attached.

Here’s what it looks like to get inside the 2010 MacBook Air.

More photos after the break…